S terminal circuit

Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P or N position for CVT models or t ...

Removal and installation

STARTER MOTOR HR16DE ...

Other materials:

Back door trim
Exploded View 1. Back door side finisher RH 2. Rear parcel shelf finisher 3. Back door side finisher LH 4. Back door lower finisher 5. Emergency lid 6. Back door pull handle : Clip : Pawl Back door pull handle : Removal and Installation REMOVAL CAUTION: • When removing, always use ...

P0201, P0202, P0203, P0204 fuel injector
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Shift position indicator circuit
Description • TCM sends position indicator signals to combination meter by CAN communication line. • Manual mode switch position is indicated on shift position indicator Component Function Check 1.CHECK SHIFT POSITION INDICATOR CAUTION: Always drive vehicle at a safe speed. 1. Start engine. ...