Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

System description

...

Other materials:

B2603 shift position
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2603 is displayed with DTC B2601, first perform the trouble diagnosis for DTC B2601. Refer to SEC-79, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Shift the selector lever to the P position. 2. ...

Starter motor drive control
Starter motor drive control : System Diagram Starter motor drive control : System DescriptionINPUT/OUTPUT SIGNAL CHART INPUT/OUTPUT SIGNAL CHART *: With Intelligent Key system SYSTEM DESCRIPTION When rapid deceleration occurs during engine runs or idle speed decreases due to heavy load c ...

Ambient sensor
Removal and Installation REMOVAL 1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation". 2. Disengage fixing pawl, and then remove ambient sensor (1) from air guide RH. : Pawl 3. Disconnect ambient sensor connector (2), and then remove ambient sensor. INS ...