Basic inspection

DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW NOTE: If any malfunction is found, immediately disconnect the battery cable from the negative terminal. 1.CHECK ENGI ...

B terminal circuit

Description The “B” terminal is constantly supplied with battery power. Diagnosis Procedure CAUTION: Perform diagnosis under the condition that engine cannot start by the following procedure. ...

Other materials:

C1109 power and ground system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

P0776 pressure control solenoid B
Description The secondary pressure solenoid valve regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION ...

Service data and specifications (SDS)
Wheel Bearing Drive Shaft M/T *: For measuring position, refer to FAX-54, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 56, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side). CVT *: For measuring position, refer to FAX-54, "WHEEL SIDE ...