Service data and specifications (SDS)

Precaution

Other materials:

P1650 thermoplunger control unit
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...

For frontal collision : When SRS is activated in a collision
CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed. 2. Replace the diagnosis sensor unit. ...

Drive belt idler pulley
Removal and Installation REMOVAL 1. Remove drive belt. Refer to EM-155, "Removal and Installation". 2. Remove the lock nut, and then remove the plate (7), idler pulley (6), and washer (5). 1 : Alternator bracket 3. Remove the center shaft (2) together with the spacer (3) with insert ...