Unit removal and installation

Transaxle assembly MR16DDT : Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-84, "MR16DDT : Removal and Installation" for the locations and tightening ...

Transaxle assembly

Exploded View CASE AND HOUSING 1. Filler plug 2. Gasket 3. Transaxle case 4. Bushing 5. Snap ring 6. Oil channel 7. Oil gutter 8. Position switch 9. Bracket 10. Differential side oi ...

Other materials:

B1177 lap Pre-tensioner RH
DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC ...

On Board Diagnostic (OBD) System of Engine and CVT
The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: • Be sure to turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection ...

Description
NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. • Before performing trouble diagnoses, read the “Work Flow” in each section. • After repairs, re-check that the problem has been completely elim ...