Service Notice or Precautions for Manual Transaxle

CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts ma ...

Special Service Tools

...

Other materials:

Engine bucking
Description CHART 9: ENGINE BUCKING Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace harness o ...

P1564 ASCD steering switch
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1564 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC-302, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

Engine maintenance (HR16DE)
Drive belt DRIVE BELT : Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cracks ...