Nissan Juke Service and Repair Manual : Position switch

Removal and Installation

REMOVAL

1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation".

2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation".

3. Disconnect position switch connector.

4. Remove position switch from transaxle case.

INSTALLATION

1. Apply recommended sealant to threads of position switch.

• Use Genuine Liquid Gasket, Three Bond 1215 or an equivalent.

CAUTION:
Remove old sealant and oil adhering to threads.

2. Install position switch to transaxle case.

3. Tighten position switch to the specified torque. Refer to TM-88, "Exploded View".

4. For the next step and after, install in the reverse order of removal.

Inspection

INSPECTION AFTER INSTALLATION

• Check continuity between position switch terminals. Refer to TM-73, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM-73, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).

• Check the oil leakage. Refer to TM-75, "Inspection".

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and I ...

    Control linkage
    Exploded View 1. Bracket 2. Shifter cable 3. Selector lever 4. Shifter lever A 5. Tapping bolt 6. Cable mounting bracket 7. Selector cable 8. Grommet 9. M/T shift selector assembly 1 ...

    Other materials:

    General Precautions
    • Do not operate the engine for an extended period of time without proper exhaust ventilation. Keep the work area well ventilated and free of any inflammable materials. Special care should be taken when handling any inflammable or poisonous materials, such as gasoline, refrigerant gas, etc. ...

    Additional service when replacing TCM
    Description Always perform the following items when the TCM is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accurat ...

    Intelligent Forward Collision Warning (I-FCW)
    WARNING The Intelligent Forward Collision Warning (I-FCW) system is a supportive safety feature; failing to adhere to the provided operational instructions or relying solely on this technology could result in a severe collision, causing serious injury or death. While the I-FCW sy ...