Nissan Juke Service and Repair Manual : Precaution for Procedure without Cowl Top Cover

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc.

Service Notice or Precautions for Manual Transaxle


    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

    Service Notice or Precautions for Manual Transaxle
    CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts ma ...

    Other materials:

    B210C starter control relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. DTC ...

    Auto operation does not operate but manual operate normally (driver side)
    Diagnosis Procedure 1.PERFORM INITIALIZATION PROCEDURE Initialization procedure is executed and operation is confirmed. Refer to PWC-16, "Work Procedure". Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK ENCODER CIRCUIT Check encoder c ...

    P1650 starter motor relay 2
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...