Structure and operation

Sectional View 1. 3rd input gear 2. 3rd-4th synchronizer hub assembly 3. 4th input gear 4. 5th input gear 5. 5th-6th synchronizer hub assembly 6. 6th input gear 7. Transaxle case 8. 6th ...

Back-up lamp switch : Component Inspection

1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-77, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspec ...

Other materials:

P0826 up and down shift SW
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. After the repair, p ...

DTC/Circuit diagnosis
POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspection result normal? YES >> INSPE ...

Door does not lock/unlock with driver side door lock knob or door key cylinder
Diagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2. NO >> Refer to DLK-254, "Component Function Check". 2.CHECK UNLOCK SENSOR Check unlock sensor. Refer to ...