Nissan Juke Service and Repair Manual : Removal and installation

POWER WINDOW MAIN SWITCH

Removal and Installation

REMOVAL

1. Remove power window main switch finisher. Refer to INT-13, "Removal and Installation".

2. Remove power window main switch (1) from power window main switch finisher (2) using flat-head screw driver (A).

CAUTION:: Pawl


CAUTION:
Do not fold the pawl of power window main switch finisher.

NOTE:

The same procedure is also performed for front power window switch (passenger side) and rear power window switch (LH & RH).

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

NOTE

:
If power window main switch is replaced or is removed, it is necessary to perform the initialization procedure.

Refer to PWC-16, "Work Procedure".

    Power window lock switch does not function
    Diagnosis Procedure 1.REPLACE POWER WINDOW MAIN SWITCH Replace power window main switch. >> Refer to PWC-44, "Removal and Installation". ...

    Other materials:

    System
    Manual air conditioning system : System Diagram Manual air conditioning system : System Description DESCRIPTION • Manual air conditioning system is controlled by each function of thermo control amp., BCM, ECM and IPDM E/R. • Fan speed of blower motor is changed by the combination of fan ...

    Bluetooth® Hands-Free Phone System
    WARNING • Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. • If you find yourself unable to devote full attention to vehicle operation while tal ...

    P0031, P0032 A/F sensor 1 heater
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...