Removal and installation

POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove power window main switch finisher. Refer to INT-13, "Removal and Installation". 2. Remove power window main switch ( ...

Vehicle information

BODY EXTERIOR PAINT COLOR Body Exterior Paint Color FOR 2WD MODELS NOTE: • S: Solid • 2S: Solid + Clear • CS: Color clear solid • M: Metallic • P: 2-Coat pearl • 3P: 3-Coat pe ...

Other materials:

Precaution
Precautions for Suspension • When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. - Unladen conditions mean that fuel, engine coola ...

Intelligent key warning buzzer
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >& ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...