Nissan Juke Service and Repair Manual : Power window lock switch does not function

Diagnosis Procedure

1.REPLACE POWER WINDOW MAIN SWITCH

Replace power window main switch.

>> Refer to PWC-44, "Removal and Installation".

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1.CHECK POWER WINDOW AUTO OPERATION Check AUTO operation when anti-pinch function does not operate. Is the inspection result normal? YES >> GO TO 2. NO >> Refe ...

    Removal and installation
    POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove power window main switch finisher. Refer to INT-13, "Removal and Installation". 2. Remove power window main switch ( ...

    Other materials:

    Engine control system
    Engine control system : Component Parts Location ENGINE ROOM COMPARTMENT 1. Boost control actuator 2. Turbocharger boost control solenoid valve 3. A/F sensor 1 4. Recirculation valve 5. EVAP canister purge volume control solenoid valve 6. Inter cooler 7. Refrigerant pressure sensor R ...

    Normal operating condition
    Description FRONT WIPER MOTOR PROTECTION FUNCTION • IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation. • At that time turn OFF the front wiper and remove the f ...

    P1651 starter motor relay
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...