Nissan Juke Service and Repair Manual : Removal and installation

Air cleaner filter
Exploded View 1. Turbocharger air inlet pipe 2. Clamp 3. Air duct (suction) 4. Air mass flow sensor 5. O-ring 6. Air duct (inlet) 7. Grommet 8. Air cleaner case 9. Air cleaner filter ...

Air cleaner and air duct
Exploded View 1. Turbocharger air inlet pipe 2. Clamp 3. Air duct (suction) 4. Air mass flow sensor 5. O-ring 6. Air duct (inlet) 7. Grommet 8. Air cleaner case 9. Air cleaner filter ...

Other materials:

P2118 throttle control motor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

Additional service when replacing transaxle assembly
Description Perform the following work after the transaxle assembly is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform ...

Three-way catalyst
The three-way catalyst is an emission control device installed in the exhaust system. Exhaust gases in the three-way catalyst are burned at high temperatures to help reduce pollutants. WARNING • The exhaust gas and the exhaust system are very hot. Keep people, animals or flammable materials ...