Nissan Juke Service and Repair Manual : Audio, Visual & Navigation System NISSAN dynamic control system
- Precaution
- System description
- Ecu diagnosis information
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- U1402 engine speed signal
- U1405 engine torque signal
- U1406 boost pressure input
- U1412 long ACC input
- U1413 trans ACC input
- Power supply and ground circuit
- Symptom diagnosis
- Removal and installation
Antenna feeder
Feeder Layout
...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Other materials:
Unit disassembly and assembly
Torque converter and converter housing oil seal
Exploded View
1. Transaxle assembly
2. Converter housing oil seal
3. Torque converter
: Always replace after every
disassembly.
: Apply CVT Fluid NS-2.
Disassembly
1. Remove transaxle assembly. Refer to TM-301, "Removal and Installat ...
Periodic maintenance
IDLE SPEED
Inspection
1.CHECK IDLE SPEED
With CONSULT-III
Check idle speed in “DATA MONITOR” mode with CONSULT-III.
With GST
Check idle speed with Service $01 of GST.
Without CONSULT-III
Check idle speed by installing the pulse type tachometer clamp on the loop
wire or on suitable ...
P1652 starter motor system COMM
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. Models with no
Intelligent Key System transmit a control signal directly to IPDM E/R. On the
other hand, models with the Intelligent
Key System transmit a control signal to IPDM E/R by w ...
