Nissan Juke Service and Repair Manual : Handling precaution

Nissan Dynamic Control System

• The engine torque, engine power, boost, and instantaneous fuel consumption are provided for information purposes only. They are not intended to prompt the driver to adjust driving style. The readings may be slightly delayed relative to the actual vehicle behaviors. This is not a malfunction.

• The voltmeter reading cannot be used as an indicator for battery replacement because it indicates the input voltage to the multi display unit, not the battery voltage.

• The SET UP screen are viewable and operable only while the vehicle is stopped.

• The ECO information screen is operable only while the vehicle is stopped.

• If no time setting is performed, the daily and weekly fuel consumption history data are not displayed.

• The readings may differ from the actual values depending on driving conditions.

    System
    NISSAN dynamic control system NISSAN DYNAMIC CONTROL SYSTEM : System Description SYSTEM DIAGRAM • *1: M/T models except for K9K engine models • *2: CVT models MULTI DISPLAY UNIT INPUT/OUTPU ...

    Diagnosis system (multi display unit)
    CONSULT-III Function APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with multi display unit. SELF DIAGNOSTIC RESULT Refer to AV-111, "DTC Index". ...

    Other materials:

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TR/BD OPEN SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back d ...

    P0611 ECM protection
    Description This DTC is detected when the ECM protective function is activated due to an extreme temperature increase in ECM, resulting from severe conditions such as heavy load driving. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE This DTC ...

    Off position warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...