Nissan Juke Service and Repair Manual : U1412 long ACC input

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Using CONSULT-III, check the “self diagnosis result” of “ABS” and repair or replace any malfunctioning parts.

>> Refer to BRC-142, "DTC Index".

    U1406 boost pressure input
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. ...

    U1413 trans ACC input
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ABS” and repair ...

    Other materials:

    Power supply and ground circuit
    MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace fuse with a new one after repairing the applicable circuit. 2.CHECK POWER SUPPLY CIRCUIT Check ...

    Ignition signal
    Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT-III: GO TO 2. YES-2 >> Without CONSULT-III: GO TO 3. NO >> Go to EC-783, "Diagnosis Procedure". 2.IGNITION SIGNAL FUNCTION ...

    Door lock status indicator
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK IND” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Door lock status in ...