Nissan Juke Service and Repair Manual : U1413 trans ACC input

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Using CONSULT-III, check the “self diagnosis result” of “ABS” and repair or replace any malfunctioning parts.

>> Refer to BRC-142, "DTC Index".

    U1412 long ACC input
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ABS” and ...

    Power supply and ground circuit
    MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace ...

    Other materials:

    Vehicle speed sensing auto lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Re ...

    Water pump
    Exploded View 1. Gasket 2. Water pump 3. Water pump pulley : Always replace after every disassembly. : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Drain engine coolant from radiator. Refer to CO-37, "Draining". CAUTION: • Perform this st ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...