U1402 engine speed signal

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. ...

U1406 boost pressure input

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. ...

Other materials:

Power generation voltage variable control system operation inspection
Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the response speed of the voltage change will become slow. This can cause an incorrect inspection.) 1.CHECK ...

Additional service when replacing control unit
ECM ECM : Description Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*. *: New one means a virgin ECM that has never been energized on-board. (In this step, initialization procedure by CONSULT-I ...

Front combination lamp
Exploded View REMOVAL 1. Front combination lamp : N·m (kg-m, in-lb) DISASSEMBLY 1. Parking lamp bulb 2. Parking lamp bulb socket 3. Front turn signal lamp bulb socket 4. Front turn signal lamp bulb 5. Front combination lamp housing Removal and Installation CAUTION: Disconnect the ...