Nissan Juke Service and Repair Manual : Diagnosis system (PTC heater control unit)
CONSULT-III Function
CONSULT-III performs the following functions via CAN communication with PTC heater control unit.
ECU IDENTIFICATION
Part number of PTC heater control unit can be checked.
SELF-DIAGNOSTIC RESULT
Diagnosis result that is judged by PTC heater control unit. can be checked. Refer to HAC-267, "DTC Index".
DATA MONITOR
Input/output signal of PTC heater control unit can be checked.
Display item list
Operation
Switch Name and Function
A/C CONTROLLER (A/C CONTROL)
1. MODE dial
2. Fan control dial
3. A/C switch
4. Temperature control dial
5. Intake lever
...
Diagnosis system (BCM) (with intelligent key system)
Description
Air conditioning system performs self-diagnosis, operation check, function
diagnosis, and various settings
using diagnosis function of each control unit.
Common item : consult-III F ...
Other materials:
Diagnosis system (IPDM E/R)
Diagnosis Description
AUTO ACTIVE TEST
Description
In auto active test mode, the IPDM E/R sends a drive signal to the following
systems to check their operation.
• Oil pressure warning lamp (only for K9K engine models)
• Rear window defogger
• Front wiper motor
• Parking lamp
• ...
Back door opener actuator
Diagnosis Procedure
1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect back door opener assembly connector.
3. Check voltage between back door opener assembly harness connector and ground.
Is the inspection result normal?
YES >> GO TO 3.
NO > ...
General Precautions
• Always use a 12 volt battery as power source.
• Do not attempt to disconnect battery cables while engine is
running.
• Before connecting or disconnecting the ECM harness connector,
turn ignition switch OFF and disconnect negative battery
cable. Failure to do so may damage the ECM becaus ...
