Nissan Juke Service and Repair Manual : Symptom diagnosis
NISSAN DYNAMIC CONTROL SYSTEM
Symptom Table

Power supply and ground circuit
MULTI DISPLAY UNIT
MULTI DISPLAY UNIT : Diagnosis Procedure
1.CHECK FUSES
Check if any of the following fuses are blown:
Is the check result normal?
YES >> GO TO 2.
NO >> Replace ...
Removal and installation
MULTI DISPLAY UNIT
Exploded View
REMOVAL
Refer to IP-12, "Exploded View".
DISASSEMBLY
1. Silencer tape
2. Multi display unit
3. Silencer tape
4. Clip
5. Control finisher
Rem ...
Other materials:
P181D engine torque signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
W ...
Temperature A, B and C
The temperature grades A (the highest), B, and C, representing the tire’s resistance
to the generation of heat and its ability to dissipate heat when tested under controlled
conditions on a specified indoor laboratory test wheel. Sustained high temperature
can cause the material of the tire ...
Service data and specifications (SDS)
DRIVE BELT (MR16DDT)
DRIVE BELT (MR16DDT) : Drive Belt
DRIVE BELT
DRIVE BELT (HR16DE)
DRIVE BELT (HR16DE) : Drive Belt
DRIVE BELT
Belt Deflection
*: When engine is cold.
Belt Tension and Frequency
*: When engine is cold.
DRIVE BELT (K9K)
DRIVE BELT (K9K) : Drive Belt
DRIVE BELT ...
