Nissan Juke Service and Repair Manual : Defogger
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Discon
- Precaution for Procedure without Cowl Top Cover
- System description
- Component parts
- System
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis systeM (BCM) (without intelligent key system)
- Diagnosis system (IPDM E/R)
- Ecu diagnosis information
- Basic inspection
- DTC/circuit diagnosis
- Rear window defogger switch
- Rear window defogger relay
- Rear window defogger
- Door mirror defogger
- Driver side door mirror defogger
- Passenger side door mirror defogger
- Rear window defogger on signal
- Rear window defogger system
- Symptom diagnosis
- All defogger system dose not operate
- Rear window defogger does not operate but both door mirror defoggers operate
- Door mirror defogger does not operate
- On is not displayed when pressing rear window defogger switch but it is operated
- Rear window defogger indicator does not illuminate
- Removal and installation
Rear washer nozzle and tube
Hydraulic Layout
1. Rear washer nozzle
2. Plug
3. Rear washer tube
4. Joint
5. Second washer tube
6. Back door seal rubber
7. Front washer tube
: Clip
: Pawl
Removal and Installation
...
Precaution
...
Other materials:
Refrigerant pressure sensor
Exploded View
Refer to HA-39, "Exploded View". (HR16DE)
Refer to HA-94, "Exploded View". (MR16DDT)
Removal and Installation
REMOVAL
Remove refrigerant pressure sensor.
Refer to HA-42, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".
(HR16DE)
Refer to ...
B1137 side air bag module LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning la ...
Malfunction indicator
Component Function Check
1.CHECK MI FUNCTION
1. Turn ignition switch ON.
2. Make sure that MI lights up.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC-1019, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK CAN COMMUNICATION LINE
Refer to LAN ...
