Nissan Juke Service and Repair Manual : Rear window defogger relay

Description

The rear window defogger is operated by turning the rear window defogger switch ON.

Component Function Check

1.CHECK FUNCTION

1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III.

2. Touch “ON”.

3. Check that the rear window heating wire is getting warmer.

Is the inspection result normal? YES >> Rear window defogger relay function is OK.

NO >> Refer to DEF-30, "Diagnosis Procedure"

Diagnosis Procedure

1.CHECK FUSE

1. Turn ignition switch OFF.

2. Check the 20A fuse (No. 41 located in IPDM E/R).

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.

2.CHECK IPDM E/R OUTPUT SIGNAL

1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III.

2. Touch “ON”.

3. Check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (With Intelligent Key system) or PCS-63, "Removal and Installation" (Without Intelligent Key system).

    Rear window defogger switch
    With auto A/C WITH AUTO A/C : Description • The rear window defogger is operated by turning the rear window defogger switch ON. • The indicator lamp in the rear window defogger switch illumin ...

    Rear window defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the rear window from fogging up. Component Function Check 1.CHECK FUNCTION 1. Perform IPD ...

    Other materials:

    SRS air bag warning lamp does not turn off
    Diagnosis Procedure 1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER Check the deployment of air bag module. Is air bag module deployed? YES >> Replace the malfunctioning parts. NO >> GO TO 2. 2.CHECK AIR BAG FUSE Check 10 A fuse [No.2, located in fuse block (J/B)]. Is ...

    B1215, B1216, B1217 satellite sensor LH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

    Seat belts with pretensioners (front seats)
    WARNING • The pretensioners cannot be reused after activation. They must be replaced together with the retractor and buckle as a unit. • If the vehicle becomes involved in a collision but a pretensioner is not activated, be sure to have the pretensioner system checked and, if necessary, re ...