Nissan Juke Service and Repair Manual : Condenser

Exploded View

Refer toINT-34, "Exploded View"

Removal and Installation

REMOVAL

1. Remove the back door lower finisher.

Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation" 2. Remove bolt (A), and then remove condenser (1) from the vehicle body.

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Filament
    Inspection and Repair INSPECTION 1. When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. 2. Attach probe circuit tes ...

    Horn
    ...

    Other materials:

    General Precautions
    • Always use a 12 volt battery as power source. • Do not attempt to disconnect battery cables while engine is running. • Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM becaus ...

    Vacuum lines
    MR16DDT : Exploded View 1. Clamp 2. Vacuum hose A 3. Vacuum piping 4. Vacuum hose B A. To engine side B. Paint mark C. To brake booster MR16DDT : Removal and Installation REMOVAL 1. Remove air duct and air cleaner case. Refer to EM-161, "Removal and Installation". 2. Remov ...

    Diagnosis system (4WD control module)
    CONSULT-III Function APPLICATION ITEMS CONSULT-III can display each diagnostic item using the diagnostic test modes as follows. *: The following diagnosis information is erased by erasing. • DTC • Freeze frame data (FFD) ECU IDENTIFICATION 4WD control module part number can be read. ...