Nissan Juke Service and Repair Manual : Heater & Air Conditioning System MR16DDT

Service data and specifications (SDS)
Compressor Lubricant Refrigerant Engine Idling Speed Refer to EC-807, "Idle Speed". Belt Tension Refer to EM-154, "Checking". ...

Other materials:

Exterior and interior lights
: See a NISSAN dealer for replacement. NOTE: Always check with the Parts Department at a NISSAN dealer for the latest information about parts. : REMOVE : INSTALL Replacement procedures All other lights are either type A, B, C, D or E. When replacing a bulb, first remove the lens and/or c ...

P0720 output speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...

G sensor calibration
Description ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. Removal/installation or replacement of G sensor Replacement of ECM Work ...