Performance test

Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition ...

Refrigeration system symptoms

Trouble Diagnosis For Unusual Pressure Diagnose using a manifold gauge whenever system’s high and/or low side pressure(s) is/are unusual. The marker above the gauge scale in the following tables i ...

Other materials:

Engine oil
Inspection OIL LEVEL AND MUDDINESS • Before starting the engine, check the oil level placing vehicle horizontally. If the engine is already started, stop it and allow 10 minutes before checking. • Make sure the oil level is within the range shown in the figure. • If it is out of range, adj ...

Back door lock
Exploded View 1. Back door lock assembly 2. TORX bolt 3. Back door striker : Do not reuse : N·m (kg-m, ft-lb) : Body grease Door lock DOOR LOCK : Removal and Installation REMOVAL 1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Ins ...

Inspection
INSPECTION AFTER REMOVAL Appearance Check the propeller shaft for bend and damage. If damage is detected, replace propeller shaft assembly. Propeller Shaft Runout Check propeller shaft runout at measuring points with a dial indicator. If runout exceeds specifications, replace propeller sh ...