Service Equipment

RECOVERY/RECYCLING RECHARGING EQUIPMENT Be certain to follow the manufacturer’s instructions for machine operation and machine maintenance. Never introduce any refrigerant other than that specifie ...

Special Service Tool

HFC-134a (R-134a) Service Tool and Equipment • Never mix HFC-134a (R-134a) refrigerant and/or its specified lubricant with CFC-12 (R-12) refrigerant and/ or its lubricant. • Separate and non-inte ...

Other materials:

C1607, C1608 EPS control unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Encoder circuit
Component Function Check 1.CHECK ENCODER OPERATION Check that front driver side door glass perform AUTO UP/DOWN operation normally when power window main switch is operated. Is the inspection result normal? YES >> INSPECTION END NO >> Refer to PWC-30, "Diagnosis Procedure& ...

Diagnosis and repair workflow
Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, transmission range switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also communicates with the ECM by means of a signal sent from sensing elements used with the OBD-related p ...