Sealant or/and Lubricant

HFC-134a (R-134a) Service Tool and Equipment • Never mix HFC-134a (R-134a) refrigerant and/or its specified lubricant with CFC-12 (R-12) refrigerant and/ or its lubricant. • Separate and non-inte ...

Component parts

Component Parts Location 1. Expansion valve 2. Condenser 3. Compressor 4. Liquid tank 5. Refrigerant pressure sensor 6. Evaporator A. Built-in heater & cooling unit assembly Componen ...

Other materials:

Hood switch
Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-223, "Diagnosis Procedure& ...

P182E 4WD solenoid right
DTC Logic DTC DETECTION LOGIC 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE (1) With CONSULT-III 1. Turn the ...

Diagnosis system [ABS actuator and electric unit (control unit)]
CONSULT-III Function APPLICATION ITEMS CONSULT-III can display each diagnostic item using the diagnostic test modes as follows. *: The following diagnosis information is erased by erasing. • DTC • Freeze frame data (FFD) ECU IDENTIFICATION ABS actuator and electric unit (control unit) p ...