Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

Precautions For Refrigerant System Service

GENERAL REFRIGERANT PRECAUTION WARNING: • Never breathe A/C refrigerant and lubricant vapor or mist. Exposure may irritate eyes, nose and throat. Use only approved recovery/recycling equipment to ...

Other materials:

P1225 TP sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Power supply and ground circuit
MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace fuse with a new one after repairing the applicable circuit. 2.CHECK POWER SUPPLY CIRCUIT Check ...

Inspection
OIL LEAKAGE Check transfer surrounding area (oil seal, drain plug, filler plug, and transfer case etc.) for oil leakage. OIL LEVEL 1. Remove filler plug (1) and gasket. Then check that oil is filled up from mounting hole for the filler plug. Vehicle front CAUTION: Never start engine while ...