Nissan Juke Service and Repair Manual : Removal and installation
Noise
Symptom Table
...
Compressor
Exploded View
REMOVAL
1. High-pressure flexible hose
2. O-ring
3. Compressor
4. O-ring
5. Low-pressure flexible hose
A. To condenser
B. To evaporator
: N·m (kg-m, ft-lb)
DISASSEMBLY
...
Other materials:
Service
• Never use electrical test equipment to check SRS circuits unless instructed
to in this Service Manual.
• Before servicing the SRS, turn ignition switch OFF, disconnect battery
negative terminal and wait at least 3
minutes.
For approximately 3 minutes after the battery negative terminal ar ...
Diagnosis system (multi display unit)
CONSULT-III Function
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with multi
display unit.
SELF DIAGNOSTIC RESULT
Refer to AV-111, "DTC Index".
DATA MONITOR
• *1: MR16DDT
• *2: This is not used to determine ON/OFF of the indicator lam ...
P0300, P0301, P0302, P0303, P0304 misfire
DTC Logic
DTC DETECTION LOGIC
When a misfire occurs, engine speed will fluctuate. If the engine speed
fluctuates enough to cause the crankshaft
position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is
occurring.
The misfire detection logic consists of the following t ...
