Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Malfunction area chart
- Main line between ipdm-e and dlc circuit
- Main line between DLC and A-bag circuit
- Main line betweeN DLC and MDU circuit
- ECM branch line circuit
- 4WD branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- TCM branch line circuit
- DLC branch line circuit
- EPS branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- A-bag branch line circuit
- HVAC branch line circuit
- MDU branch line circuit
- PTC branch line circuit
- BCM branch line circuit
- Can communication circuit
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Interview Sheet
NOTE:
Refer to LAN-17, "Trouble Diagnosis Procedure" for how to use interview sheet.
...
Malfunction area chart
Main Line
Branch Line
Short Circuit
...
Other materials:
P1643 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect thermoplunger control unit harness connector.
3. Check the voltage between thermoplunger control unit harness connector and
ground.
Is the ...
B2622 inside antenna
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode.
3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK ...
Headlamp aiming adjustment
LHD
LHD : Description
PREPARATION BEFORE ADJUSTING
NOTE:
• For details, refer to the regulations in your own country.
• Perform aiming if the vehicle front body has been repaired and/or the headlamp
assembly has been
replaced.
Before performing aiming adjustment, check the following.
...
