Nissan Juke Service and Repair Manual : Charging System
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Power Generation Voltage Variable Control System
- Preparation
- System description
- Wiring diagram
- Basic inspection
- Diagnosis and repair workflow
- Charging system preliminary inspection
- Power generation voltage variable control system operation inspection
- DTC/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
Removal and installation
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and
Installation".
2. Remove the push-button ignition switch.
...
Precaution
...
Other materials:
Car phone or CB radio
When installing a car phone or a CB radio in your vehicle, be sure to observe
the following precautions, otherwise the new equipment may adversely affect the
electronic control modules and electronic control system harness.
WARNING
• A cellular phone should not be used for any purpose ...
Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “FAN ON SIG” in “DATA MONITOR” mode, and check status under the
following condition.
Is the inspection result ...
HR16DE : Removal and Installation
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to PG-124,
"Removal and Installation".
2. Remove radiator reservoir tank. Refer to CO-17, "Exploded View".
3. Disconnect harness connectors (1) from battery terminal with
fusible link.
4. Remove harn ...
