Power generation voltage variable control system operation inspection

Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the respons ...

B terminal circuit

Description “B” terminal circuit supplies power to charge the battery and to operate the vehicle’s electrical system. Diagnosis Procedure 1.CHECK “B” TERMINAL CONNECTION 1. Turn igniti ...

Other materials:

Service Notice or Precaution
OBD SELF-DIAGNOSIS (WITH OBD) • CVT self-diagnosis is performed by the TCM in combination with the ECM. The results can be read through the blinking pattern of the malfunction indicator (MI). Refer to the table on TM-159, "CONSULT-III Function (TRANSMISSION)" for the indicator use ...

B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE With CONSULT-III 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III. 3. Check DTC. Is DTC detected? YES >> Refer to HAC-157, "Dia ...

B209F cranking request circuit
DTC Logic DTC DETECTION LOGIC NOTE: If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Re ...