Nissan Juke Owners Manual : Safety — Seats, seat belts and supplemental restraint system
- Seats
- Head restraints/Headrests
- Adjustable head restraint/headrest components
- Non-adjustable head restraint/headrest components
- Remove
- Install
- Adjust
- Front-seat Active Head Restraints
- Seat belts
- Precautions on seat belt usage
- Pregnant women
- Injured persons
- Three-point type seat belt
- Seat belt extenders
- Seat belt maintenance
- Child safety
- Child restraints
- Precautions on child restraints
- Lower Anchors and Tethers for CHildren System (LATCH)
- Rear-facing child restraint installation using LATCH
- Rear-facing child restraint installation using the seat belts
- Forward-facing child restraint installation using LATCH
- Forward-facing child restraint installation using the seat belts
- Installing top tether strap
- Booster seats
- Supplemental restraint system
- Precautions on supplemental restraint system
- NISSAN Advanced Air Bag System (front seats)
- Front seat-mounted side-impact supplemental air bag and roof-mounted curtain side-impact supplemental air bag systems
- Seat belts with pretensioners (front seats)
- Supplemental air bag warning labels
- Supplemental air bag warning light
- Repair and replacement procedure
Warning and indicator lig
: if so equipped ...
Seats
WARNING
• Do not ride in a moving vehicle when the seatback is reclined. This can
be dangerous. The shoulder belt will not be against your body. In an accident, you
could be thrown into it and ...
Other materials:
Front wheel hub and knuckle
Exploded View
1. Steering knuckle
2. Splash guard
3. Hub bolt
4. Wheel hub assembly (Bearing-integrated
type)
5. Disc rotor
6. Wheel hub lock nut
7. Adjusting cap
8. Cotter pin
A. Tightening must be done following the installation procedure. Refer to
FAX-43, "Removal and Insta ...
Precaution Necessary for Steering Wheel Rotation after Battery Discon
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Antenna
To remove the antenna, hold the bottom of the antenna and turn it counterclockwise.
To install the antenna, turn the antenna clockwise and tighten.
CAUTION
• To avoid damaging or deforming the antenna, be sure to fold down (if so
equipped) or remove the antenna under the following conditions. ...
