For side and rollover collision : When SRS is not activated in a collision

CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all ...

Driver air bag module

Exploded View 1. Steering column upper cover 2. Steering column assembly 3. Steering column lower cover 4. Side lid LH 5. TORX bolt 6. Driver air bag module 7. TORX bolt 8. Side lid RH ...

Other materials:

Readiness for Inspection/Maintenance (I/M) test
WARNING A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make sure you inform test facility personnel that your vehicle is equipped with AWD before it ...

M&A branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). Is the inspection result n ...

U0140 lost communication (BCM)
Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...