Seat belt pre-tensioner

Exploded View Refer to SB-4, "Exploded View". Removal and Installation For removal and installation procedures, refer to SB-5, "SEAT BELT RETRACTOR : Removal and Installation" ...

Disposal of air bag module

Driver air bag module : Deployment CHECKING DEPLOYMENT TOOL Connecting to Battery CAUTION: The battery must show voltage of 9.6 V or more. Remove the battery from the vehicle and place it on dry ...

Other materials:

B210C starter control relay
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. ...

Engine bucking
Description CHART 9: ENGINE BUCKING Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace harness o ...

Front door glass
Exploded View 1. Front door panel 2. Lower sash (front) 3. Sealing screen 4. Pull handle bracket 5. Front door glass run 6. Front door glass 7. Power window motor 8. Front door regulator assembly 9. Lower sash (rear) : Vehicle front Removal and Installation REMOVAL 1. Fully open ...