Diagnosis sensor unit

Exploded View 1. Diagnosis sensor unit : Vehicle front : Do not reuse : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery ...

Lap pre-tensioner

Exploded View Refer to SB-4, "Exploded View". Removal and Installation For removal and installation procedures, refer to SB-5, "SEAT BELT RETRACTOR : Removal and Installation" ...

Other materials:

Speed limiter main switch
Component Function Check 1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “ENGINE” using CONSULT-III. 3. Select “SL MAIN SW” in “DATA MONITOR” mode. 4. Check “SL MAIN SW” indication under the following condition. Without CONSU ...

Vehicle security system cannot BE set
INTELLIGENT KEY INTELLIGENT KEY : Description Armed phase is not activated when door is locked using Intelligent Key. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom. CONDITION O ...

P1813 4WD mode switch
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...