Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Back door opener actuator
- Back door opener switch
- Door lock actuator
- Door lock and unlock switch
- Door lock status indicator
- Door switch
- Hazard function
- Key switch
- Keyfob battery
- Remote keyless entry receiver
- Super lock actuator
- Unlock sensor
Keyfob id registration
Description
Perform the following procedure after BCM is replaced or when new keyfob ID
is registered
NOTE:
When registering the keyfob ID, perform only one procedure to simultaneously
register ...
Back door opener actuator
Diagnosis Procedure
1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect back door opener assembly connector.
3. Check voltage between back door opener assembl ...
Other materials:
Speed limiter main switch
Component Function Check
1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION
1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals under the following
conditions
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC-1020, "Diagnosi ...
Component parts
Component Parts Location
1. Door request switch (driver side)
2. Door mirror (driver side)
3. Remote keyless entry receiver
Refer to DLK-21,
"Component Parts Location"
4. Door mirror remote control switch
5. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Component Parts Loca ...
Lubricant
Description
MAINTENANCE OF LUBRICANT LEVEL
The compressor lubricant is circulating in the system together with the
refrigerant. It is necessary to fill compressor
with lubricant when replacing A/C system parts or when a large amount of
refrigerant leakage is
detected. It is important to alwa ...
