Nissan Juke Service and Repair Manual : Keyfob id registration

Description

Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE

:
When registering the keyfob ID, perform only one procedure to simultaneously register both ID (IMMOBILIZER ID and keyfob ID).

Work Procedure

1.STEP 1

Close all doors.

>> GO TO 2.

2.STEP 2

Operate lock using the driver side door lock and unlock switch.

>> GO TO 3.

3.STEP 3

1. Remove and insert the key into the ignition key 6 times within 10seconds (turning the key switch from OFF to ON counts as 1 time).

2. Hazard warning lamp blinks(2 times).

NOTE

:
On the sixth key insertion, keep the key in the cylinder with the key switch ON.

Does the hazard lamp blink? YES >> GO TO 4.

NO >> GO TO 1.

4.STEP 4

Within 3 seconds after the hazard lamp blinks, turn ignition switch to the ACC position and operate lock using the driver side door lock and unlock switch.

>> GO TO 5.

5.STEP 5

1. Press the lock or unlock button of the keyfob to be added.

2. All doors unlock simultaneously.

3. Hazard warning lamp blinks(2 times).

4. Key ID is registered.

Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.

YES-2 >> When ending registration: GO TO 8.

NO >> GO TO 1.

6.STEP 6

Operate lock using the driver side door lock and unlock switch.

>> GO TO 7.

7.STEP 7

1. Press the lock or unlock button of the keyfob to be added.

2. All doors unlock simultaneously.

3. Hazard warning lamp blinks(2 times).

4. Key ID is registered.

Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.

YES-2 >> When ending registration: GO TO 8.

NO >> GO TO 6.

8.STEP 8

Open the front door driver side.

>> REGISTRATION END

    Diagnosis and repair work flow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get the detailed information from the customer about the symptom (the condition and the environment when the incident ...

    Other materials:

    Diagnosis system (4WD control module)
    CONSULT-III Function APPLICATION ITEMS CONSULT-III can display each diagnostic item using the diagnostic test modes as follows. *: The following diagnosis information is erased by erasing. • DTC • Freeze frame data (FFD) ECU IDENTIFICATION 4WD control module part number can be read. ...

    Unit removal and installation
    Engine assembly Exploded View 1. Engine mounting assembly (RH) 2. Rear engine mounting bracket 3. Rear torque rod 4. Engine mounting bracket (LH) 5. Stud bolt 6. Engine mounting bracket (LH) 7. Engine mounting insulator (LH) 8. Mass damper : N·m (kg-m, ft-lb) CAUTION: Check tha ...

    Jump starting
    To start your engine with a booster battery, the instructions and precautions below must be followed. WARNING • If done incorrectly, jump starting can lead to a battery explosion, resulting in severe injury or death. It could also damage your vehicle. • Explosive hydrogen gas is always p ...