Nissan Juke Owners Manual : Exterior front

1. Hood


1. Hood
2. Windshield wiper and washer — Switch operation
— Blade replacement
— Window washer fluid
3. Parking lights, turn signal lights and front side marker lights — Switch operation
— Bulb replacement
4. Moonroof
5. Side turn signal lights — Switch operation
— Bulb replacement
6. Power windows
7. Outside mirrors
8. License plate installation 9. Recovery hook
10. Fog lights
— Switch operation
— Bulb replacement
11. Headlights
— Switch operation
— Bulb replacement
12. Tires
— Wheels and tires
— Flat tire
— Tire Pressure Monitoring System (TPMS) 13. Doors
— Keys
— Door locks
— Remote keyless entry system — Intelligent Key system — Security system

: if so equipped

    Seats, seat belts and Supplemental Restraint System (SRS)
    1. Rear head restraints 2. Child restraint anchor points (for top tether strap child restraint) 3. Front head restraints — Front-seat Active Head Restraints 4. Roof-mounted curtain side-impa ...

    Exterior rear
    1. Lift gate — Intelligent Key system 2. Rear window wiper and washer — Switch operation — Window washer fluid 3. Rear spoiler 4. High-mounted stop light 5. Antenna — Satellite radio ...

    Other materials:

    P0132 A/F sensor 1
    DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately high. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ig ...

    P1701 TCM
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701” will be indicated when replacing TCM, perform diagnosis after erasing “SELF-DIAG RESULTS” DTC Lo ...

    B1183 lap Pre-tensioner LH
    DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC ...