Normal operating condition

Description NOTE: For Navigation system operation information, refer to Navigation system Owner's Manual. BASIC OPERATIONS NOTE: Locations stored in the Address Book and other memory functi ...

Navi control unit

Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove NAVI control unit screws. 3. Disconnect NAVI control unit connectors to remove NAVI c ...

Other materials:

Operation inspection
Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...

4WD mode indicator lamp (4WD-V)
Component Function Check 1.4WD MODE INDICATOR LAMP OPERATION CHECK 1. Turn the ignition switch ON. 2. Change 4WD mode switch to “4WD-V”. 3. Check that 4WD mode indicator lamp (4WD-V) turns on. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to diagnosis proc ...

B1135 side air bag module LH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...