Nissan Juke Service and Repair Manual : Rear door speaker
Removal and Installation
REMOVAL
1. Remove rear door finisher. Refer to INT-16, "Exploded View".
2. Remove rear door speaker screws, then disconnect rear door speaker connector and remove rear door speaker.
INSTALLATION
Install in the reverse order of removal.
Tweeter
Removal and Installation
REMOVAL
1. Remove front pillar garnish. Refer to INT-18, "Exploded View".
2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter.
INSTALL ...
Antenna base
Exploded View
1. Antenna rod
2. Antenna base
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Remove headlining. Refer to INT-26, "Exploded View".
2. Disconnect antenna fee ...
Other materials:
Front wiper blade
Exploded View
1. Wiper blade
2. Wiper arm
Removal and Installation
REMOVAL
Push up the lever (A) of wiper blade (1), while sliding wiper blade
toward the direction of the arrow to remove it from wiper arm (2).
CAUTION:
Be careful not to drop the wiper blade onto the windshield
glass.
...
Performance test
Inspection
INSPECTION PROCEDURE
1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold
gauge.
2. Start the engine, and set to the following condition.
Test condition
3. Maintain test condition until A/C system becomes stable. (Approximately 10
minutes)
4. Check t ...
Diagnosis system (BCM)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...
