Nissan Juke Service and Repair Manual : Tweeter

Removal and Installation

REMOVAL

1. Remove front pillar garnish. Refer to INT-18, "Exploded View".

2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter.

INSTALLATION

Install in the reverse order of removal.

    Front door speaker
    Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT-13, "Exploded View". 2. Remove front door speaker screws, then disconnect front door speaker connector and r ...

    Rear door speaker
    Removal and Installation REMOVAL 1. Remove rear door finisher. Refer to INT-16, "Exploded View". 2. Remove rear door speaker screws, then disconnect rear door speaker connector and remo ...

    Other materials:

    Idle neutral control learning
    Description TCM corrects an individual difference in clutch clearance of the transaxle assembly by performing the idle neutral control learning and enables accurate idle neutral control. Therefore, it is required to perform idle neutral control learning after the following work is performed ...

    Back-up lamp switch : Component Inspection
    1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-77, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspection result normal? YES >> INSPECTION END NO >> Replace position switch. Refer to TM-7 ...

    Hood
    Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Hood assembly HOOD ASSEMBLY : Removal and Installation CAUTION: • Operate with two workers, becau ...