Nissan Juke Service and Repair Manual : Front door speaker

Removal and Installation

REMOVAL

1. Remove front door finisher. Refer to INT-13, "Exploded View".

2. Remove front door speaker screws, then disconnect front door speaker connector and remove front door speaker.

INSTALLATION

Install in the reverse order of removal.

    Navi control unit
    Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove NAVI control unit screws. 3. Disconnect NAVI control unit connectors to remove NAVI c ...

    Tweeter
    Removal and Installation REMOVAL 1. Remove front pillar garnish. Refer to INT-18, "Exploded View". 2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter. INSTALL ...

    Other materials:

    Exterior lighting system symptoms
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. With daytime running light system WITH DAYTIME RUNNING LIGHT ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto vehicles, and ea ...

    B1036 crash zone sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...