Nissan Juke Service and Repair Manual : Navi control unit

Removal and Installation

REMOVAL

1. Remove cluster lid C. Refer to IP-12, "Exploded View".

2. Remove NAVI control unit screws.

3. Disconnect NAVI control unit connectors to remove NAVI control unit and brackets as a single unit.

4. Remove brackets screws to remove NAVI control unit.

INSTALLATION

1. Install in the reverse order of removal.

2. Enter the anti-theft code. Refer to AV-65, "Work Procedure".

    Front door speaker
    Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT-13, "Exploded View". 2. Remove front door speaker screws, then disconnect front door speaker connector and r ...

    Other materials:

    TCM
    Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation NOTE: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM. Refer to TM-374, "Description". REMOVAL 1. Remove the battery. Refe ...

    Service Notice or Precautions for Manual Transaxle
    CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and In ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...