GPS antenna

Feeder Layout Removal and Installation REMOVAL 1. Remove instrument panel. Refer to IP-12, "Exploded View". 2. Remove antenna feeder clip, then remove GPS antenna screw and remove GPS ...

Steering switch

Exploded View Refer to SR-13, "Exploded View". Removal and Installation REMOVAL Refer to SR-13, "Removal and Installation". INSTALLATION Install in the reverse order of rem ...

Other materials:

Test Value and Test Limit
The following is the information specified in Service $06 of ISO 15031-5. The test value is a parameter used to determine whether a system/circuit diagnostic test is OK or NG while being monitored by the ECM during self-diagnosis. The test limit is a reference value which is specified as the ...

Door motor
Diagnosis Procedure NOTE: If all of door motor DTCs are detected, check this circuit. 1.CHECK DOOR MOTOR POWER SUPPLY 1. Turn ignition switch ON. 2. Check voltage between intake door motor harness connector and ground. Is the inspection result normal? YES >> GO TO 2. NO >> ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...