Microphone

Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Remove microphone connector and pawl to remove microphone. INSTALLATION Install in the reve ...

Rear view camera

Removal and Installation REMOVAL 1. Remove back door lower finisher. Refer to INT-34, "Exploded View". 2. Remove rear view camera screws to remove rear view camera. INSTALLATION Insta ...

Other materials:

Power supply and ground circuit
PTC HEATER CONTROL UNIT : Diagnosis Procedure 1.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuses (No. 3 and 7). NOTE: Refer to PG-23, "Fuse and Fusible Link Arrangement". Is the inspection result normal? YES >> GO TO 2. NO >> Replace the blown fuse after ...

C1109 power and ground system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

Brake master cylinder
Exploded View 2WD 1. Reservoir cap 2. Oil strainer 3. Reservoir tank 4. Cylinder body 5. O-ring 6. Grommet 7. Pin : Apply polyglycol ether lubricant : Apply brake fluid. : N·m (kg-m, ft-lb) : Always replace after every disassembly. 4WD 1. Reservoir cap 2. Oil strainer ...