Steering switch

Exploded View Refer to SR-13, "Exploded View". Removal and Installation REMOVAL Refer to SR-13, "Removal and Installation". INSTALLATION Install in the reverse order of rem ...

USB connector and AUX jack

Removal and Installation REMOVAL 1. Remove cluster tray. Refer to IP-12, "Exploded View". 2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack. INSTALL ...

Other materials:

P0706 transmission range sensor A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...

P2119 electric throttle control actuator
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

P1650 starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...