Nissan Juke Service and Repair Manual : USB connector and AUX jack

Removal and Installation

REMOVAL

1. Remove cluster tray. Refer to IP-12, "Exploded View".

2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack.

INSTALLATION

Install in the reverse order of removal.

    Rear view camera
    Removal and Installation REMOVAL 1. Remove back door lower finisher. Refer to INT-34, "Exploded View". 2. Remove rear view camera screws to remove rear view camera. INSTALLATION Insta ...

    Antenna feeder
    Feeder Layout ...

    Other materials:

    B1177 lap Pre-tensioner RH
    DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refe ...

    P0420 three way catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

    L terminal circuit (open)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warnin ...