Squeak and rattle trouble diagnoses

Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

Hood

Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Ho ...

Other materials:

C1164, C1165 CV system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

P1611 ID discord, IMMU-ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Go to SEC-53, "Diagnosis Procedure". NO ...

Performance test
Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition 3. Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) 4. Check t ...