Door switch

Exploded View 1. Door switch 2. TORX bolt Removal and Installation REMOVAL Remove the TORX bolt (A), and then remove door switch (1). INSTALLATION Install in the reverse order of removal. ...

Keyfob battery

Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) ...

Other materials:

P0744 torque converter
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE OPERATION 1 If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. ...

ECU diagnosis information
ECM Reference Value TERMINAL LAYOUT PHYSICAL VALUES NOTE: • ECM is located in the engine room left side near battery. • When disconnecting ECM harness connector (1), loosen (B) it with levers as far as they will go as shown in the figure. 2 : ECM A : Fasten • Pulse signal is measur ...

Refilling
1. Install reservoir tank if removed and radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-42, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-228, &q ...